1. General:
1.1 Introduction
This operating manual is valid for the submersible pressure pump of the type series TDP.
If the instructions of the operation manual – especially the safety instructions - are not ob-served, or in case
of unauthorized modifications of the device or the installation of non-original spare parts, the guarantee
expires automatically. The manufacturer assumes no liability for damages resulting from such behaviour!
Such as any other electrical device, this product may fail due to absence of mains voltage or a technical
failure. If damage could occur, an emergency power supply, a second plant and/or an off-grid alarm device
should be provided according to the application. We as manufacturer are at your disposal for consultation
also after the purchase. In case of failures or damages, please contact your retailer.
Manufacturer: ZEHNDER Pumpen GmbH
Zwönitzer Straße 19
08344 Grünhain-Beierfeld
Date of manufacture: The date of manufacture of the pump is engraved on the top of the housing.
Manufactured size:
State of the operation manual: July 2008
1.2 Enquiries and orders:
In case of enquiries or orders, address yourself to your specialist retailer and/or retail seller.
1.3 Technical data:
TYPE:
Pressure pipe
connector
max.
particle size
Input power P
1
Output power P
2
Power reception
Supply cable
Floating switch
max. discharge flow
max. discharge height
Materials:
Pump housing:
Polypropylene (PP)
Outer housing:
Polypropylene (PP-GF30)
Bottom filter:
Polyethylene (PE)
Motor housing:
Stainless steel 1.4301
Diffuser:
Polyamide (PA-GF)
The submersible pumps of the type series TDP is applicable up to a liquid temperature of 40 °C.
TDP 800
TDP 800
G1-3/4"
or
G1-1/2"
3 mm
760 W
410 W
2.9 A
10 m
2
3 x 1mm
ja
6000 l/h
30 m
Running wheel
Polyamide (PA-GF)
Floating switch:
Polypropylene (PP)
Screws:
Stainless steel 1.4301
Mechanical seal:
Coal/ceramics/NBR/stainless steel
Cover:
Polyamide (PA-GF)
13