Tips On Measurement - Powerfix Profi HG04213A Instructions D'utilisation Et Consignes De Sécurité

the AC search, the detector can be guided in
all the four directions (Fig. B).
  
I ntegrated Pencil:
A pencil
the delivery content. Included pencil
be stored inside the product by inserting the
pencil
4
on the right side of the product. Make sure to
insert the pencil
pencil hole on the product. When necessary,
the pencil
cil hole.

Tips on measurement


 
T he PUSH button
during the entire search process (calibration
and search).
 
I f you calibrate too closely to the object or di-
rectly on the object, the calibration can fail. If
the calibration fails, the LC display shows the
full intensity (Fig. C) and a long beeping tone
sounds or can't search any object in the wall.
Move and hold the product several centimeters
further to the right or left of the previous surface
and recalibrate. Start the search process.
 
R epeat several times to ensure the detection
accuracy.
 
I ncorrect measurements can occur depending
on the nature of the examined wall. Check
therefore before every measurement the posi-
tion of a known wooden or metal beam, of a
known void or a known power line. If these
are not detected by the product, the substrate
is not suitable for a search with this product.
has been included together with
4
on the pencil hole, which is located
into the intended slot of the
4
can be taken out from the pen-
4
must remain pressed
5
can
4
GB/IE/NI 13