Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFEGUARDS
Read all instructions before using.
Important information is highlighted by these terms:
WARNING– Important safety information for hazards that
might cause serious injury.
CAUTION– Information for preventing damage to
the product.
NOTE– Information to which you should pay
special attention.
READ ALL INSTRUCTIONS BEFORE USING.
WARNINGS:
Please read carefully before use. Failure to comply may result in severe injury.
DO NOT
exceed the 250 lbs (113 kg) maximum weight capacity of this safety frame.
Evenly distribute weight between the armrests during use.
Ensure all detent buttons are properly engaged in position prior to use.
FAILURE TO FOLLOW INSTRUCTIONS MAY
RESULT IN SERIOUS INJURIES.
SAVE THESE INSTRUCTIONS.
1 MEDLINE | PIC-00373 (Rev.: 11-15-2018)
ASSEMBLY INSTRUCTIONS
Before beginning assembly, identify all parts (Figure 1)
1. Remove existing toilet seat assembly, including bolts and nuts.
2. Place toilet safety frame bracket between toilet fixture and seat assembly
with rounded part of bracket closest to the back of toilet (Figure 2).
3. Replace toilet seat assembly and reinsert the original mounting bolts through
front holes of the bracket and toilet fixture (Figure 3). Tighten the nuts.
4. Depress the built-in snap buttons and tighten the locking collar on each side
of the safety frame (Figure 4).
5. Slide each side frame into desired width position. Insert black adjustments
hand knobs to the bracket and tighten to secure into place (Figure 5).
6. Adjust foot pieces to desired height (Figure 6). Make sure both foot pieces are
fully engaged and adjusted at equal heights.
7. Make sure mounting hardware is tightened and all snap buttons are fully
secure before use.
Figure 1
Figure 2
Figure 4
Figure 5
Figure 3
Figure 6
1-800-MEDLINE (633-5463) | medline.com 2
Publicité
