13) Input Gain Controls
Each main input channel has a gain control offering <-70 to + 10dB gain range
allowing compensation for differing input levels.
14) Input Selection Buttons
Selects either CD/Line/USB/Mic on channels 1 and 4 or Phono/Line/USB/Mic/CD on
channels 2 and 3.
15) Music Channel Equalizer
Each music channel has a 3 band EQ stage providing comprehensive control over
individual input EQ Content.
Each Control 'Bass'
Each Control 'Midrange'
Each Control 'Treble'
16) 45mm Fader
The slider sets the signal level of the channel being mixed onto the main Left/Right
Output channels or sent to the fully assignable crossfader.
17) Removable Crossfader
This dipless 45mm crossfader is fully assignable to any of the four main music
channels set by setting the "Assign Switches" (19)
The Crossfader is easily and quickly replaced by removing the 2 outer pozi
countersunk screws on the crossfader panel and unplugging attached ribbon
connector.
18) Punch buttons
Create effects such as transforming and dub beat by transposing the program from
one side of the crossfader directly onto the other side.
19) Assign Switches
Any of the four music channels can be assigned to either side of the crossfader by
the setting of these switches.
NOTE: If the same channel is assigned to both sides of the crossfader at either extreme that channel
will be muted but the channel will be live when the crossfaders at its centre position. This setting can
give the effect of "faster dub fading" when crossfader is used from its centre to either extreme.
20) Balance Control
This control is used to set the stereo balance of the master Left/Right outputs. The
Master option program can be fully panned to the left or right.
21) Master Output Fader Control
This slider controls the overall output level leaving the mixer at its master balanced
XLR and Unbalanced phono Socket outputs.
22) Balanced Outputs
Master stereo program output provided by 3 pin Male XLR sockets:
Output wiring: (Balanced):
Nominal output level (Balanced):
Impedance:
©Copyright Lotronic 2011
Allowing -26dB Cut, +12dB Boost
Allowing -26dB Cut, +12dB Boost
Allowing -26dB Cut, +12dB Boost
Pin 1 – Ground
Pin 2 – Positive
Pin 3 – Negative
0dBu (775mV rms)
Output < 50 Ohm
Minimum Load 600 Ohm
Page 5