Remote Controller - AVer VC520 Pro Mode D'emploi

4.
Connect the camera to the computer.
[Note] Use the USB 3.0 cable that is included
in package.

Remote Controller

Camera Select
Camera Directional
Control
OSD Menu**
SmartFrame
Zoom In/Out
Preset
Brightness -
Call/Answer*
*Function requires AVer PTZApp
**Not supported for VC520 Pro
Enter**
English-4
USB cable
 Camera Select: If you only have
one camera and don't need to
adjust custom settings, the default
is camera 1. If you press camera 2
or 3 on the remote control, you will
find your remote can't control your
camera. In this case, please press
camera 1 on your remote again.
 SmartFrame: Press and hold
on the remote for 2 seconds
to switch the SmartFraming
function between auto and manual
mode; a message (as figure
shown) will display on the screen
to indicate auto or manual mode.
[Note] While in the video
conference meeting, participants
must face the camera for proper
face detection (SmartFrame). Side
facial profiles are not detectable.
 Press and hold the number button
" " to turn the WDR function on
or off.
 AAA Batteries (required)