Publicité
Les langues disponibles
Les langues disponibles
Fig.1 Parts list
(1)
Monitor.
(4)
Main post.
(44) Handlebar stem.
(72) Main body.
(146) Bottle holder.
(149) Bracket cover.
(150) Focus bar spindle covers (L).
(151) Focus bar spindle covers (R).
(152) Covers main post right (R).
(153) Covers main post left (L).
Fig.2 Screws and fasteners
(154) Allen screws M8x55.
(155) Screws M3x16.
(38) Screws M4x40.
(156) Self locking nuts M8.
(157) Washers M8 Ø 16.
(158) Allen screws M8x20.
(159) Washers M8 Ø 16.
Combination box spanner.
Allen key.
2. FITTING THE MAIN POST.-
Insert the left focus bar (20) onto the
focus bar spindle (10), Fig.3A, then fit
the right focus bar (32) on the other
end of the spindle. Fit the bolts (13)
and the flat washers (12) and tighten
securely.
Take the covers (35) (39), and position
them at the spindle end with the bars
on the right hand side, as shown in
Fig.3A. Now use screws and (36) (38)
to attach them. Carry out the same
procedure at the other end of the bar
using the covers (25) (29) marked on
the inside with the letter "L".
Be sure that the bushes (11) are in
the correct position. Fig 3A.
Pass the cable (73) through the main
post (167) using the guide (171).
Bring the main post (167) up to the
boss on the main body (72) in the
direction of the arrow, Fig.3A, making
sure not to snag any of the cables.
Drive the screws (168) together with
the washers (169) and washers (170)
and tighten securely.
Take the main post (4) and remove
the
screws
washers (16) and spring washers (17)
from the bottom of the post. Fig.3B.
Next, bring the main post (4) up to
boss (D) on the main body (72),
Fig.3B, connect the terminals (73) and
(19), Fig.3B.
Slip the main post (4) over the boss
(D) on the main body (72) in the
direction of the arrow, Fig.3B, making
sure not to snag any of the cables.
Refit the screws (15), the washers
(16) and the spring washers (17) that
you removed previously, and tighten
securely.
ATTENTION: It is advisable to
retighten these screws after one
month of using the machine.
3. FITTING THE FOOT BARS.-
Take the left foot bar (50) and position
it on the "U" at the bottom of the left
focus bar (20), Fig.4.
Insert screw (154), as shown in
Fig.4A, then fit the flat washer (157)
and the self locking nut (156), and
tighten securely.
Take the right foot bar (61) and go
through the same assembly procedure
as with the left.
4. FITTING THE FOCUS BAR
SIDE COVERS TO THE FOOT
BARS.-
Take the covers (150 and 151),
marked on the inside with the letter
"R", and position them at the end of
the foot bars with the inside of the
focus bars on the right hand side, as
14
(15)
the
corrugated
Publicité
