How To Operate; Part Description - Princess 352610 Mode D'emploi

HOW TO OPERATE:

Control panel with off button and 2 or 3 speed buttons (10)
ART. 352610 & 352620:
0 Switches the motor off
1,2,3 3 different fan speeds; 1 = low, 2 = medium, 3 = high
ART. 352630:
0 Switches the motor off
1,2 2 different fan speeds; 1 = medium, 2 = high
Knob for automatic swivelling on/off (8)
Pull up: automatic swivelling is switched off.
Press down: switches swivelling on.
Pre-determined settings for fan tilting (9)
The fan can be tilted by hand up or down in a certain amount of pre-determined positions. Just push the
Handle up or down and it will hinge around the Hinge point.

PART DESCRIPTION:

1. Front Guard
2. Blade lock nut
3. Fan blade
4. Guard lock nut
5. Rear Guard
6. Handle
7. Motor
8. Swivel on/off knob
9. Tilt hinge point
10. Base with control panel
ASSEMBLING THE FAN
1. Remove the Blade lock nut from the shaft of the Motor.
2. Remove the Guard lock nut. Position the Rear guard onto the Motor making sure that the pins on the
Motor match with the holes on the Rear guard. Fix the Rear guard by screwing the Guard lock nut back
on tightly (fig. 1).
3. Insert the Fan blade onto the shaft of the Motor. Be sure that the pin on the shaft is positioned inside
the slot on the Fan blade.
4. Screw the Blade lock nut onto the Motor shaft to make sure the Fan blade is tightly fixed (fig. 2).
5. Mount the Front guard to the Rear guard (fig. 3).
CLEANING
Before cleaning, turn fan off and unplug from electrical outlet. Wipe off excess dust with
a lint free cloth. A vacuum cleaner hose can be used to clean this area if desired. Should
the fan housing become soiled, it can be cleaned with warm (not hot) soapy, mild detergent
solution. Then dry. Do not submerse your fan in water or any other liquid. Do not allow
any liquid to get into the fan or motor. Your fan is equipped with a thermally protected
permanently lubricated motor. No oiling is necessary.
NEVER IMMERSE THE FAN IN WATER OR OTHER LIQUID.
6