Default Parameters; Functioning; Credit Totalizer - Favero Electronics CT02 Mode D'emploi

ENGLISH

2.2 Default parameters

Following is a list of default parameters for
programming, as shown in the "CONFIG.INI" file.
[Common]
P0.4 = €
P0.5 = 0000.50
P0.6 = 1
P0.7 = 00m00s
P0.8 = 00m00s
P0.10 = 1
P0.11 = 99999
Log = 1
[Service_01]
P1.2 = 00h00m30s
P1.3 = 00m02s
P1.4 = 00m00s
P1.5 = 00m00s
3 F
UNCTIONING
Before using the CT02, we suggest you
programme
indications found in the 2.1.
Following is a table with the functioning statuses of
the CT02.
CT02 Status LED Status
OFF
Flashing every 2
STAND-BY
seconds
ON
Flashing every 0.5
PAUSED
seconds
To ACTIVATE service, place the prepaid card near
the CT02 reader area. The internal buzzer will emit
a short beep to indicate that the card has been
recognized, that the card's credit has been
updated, and that the relay or solenoid valve for the
programmed time has been activated.
A PAUSE can be activated in the following ways:
• manually, by programming the P1.3 parameter
and connecting a button to the appropriate input;
• automatically, by programming the P2.4 and
P1.5 parameters.
By placing the prepaid card near the CT02 reader
area, the internal buzzer will emit a long beep to
warn that service has not been activated in
following situations:
00182-M07-01-ML User manual CT02
it according
Status of service
Off Off
Off
On On
Paused
• if credit in the card is insufficient (less than the
base
parameter);
• if service is already activated and it is not
possible to increase the duration as the
accumulation of time (P0.6 parameter) has not
been enabled;
• if the card is not valid (the system code of the
card is different from that of the CT02, or the
card has not been programmed, or is damaged).
4 C
REDIT
WARNING: to verify the totalizer you must
have
"CONFIG.INI" file in which the parameter
"Log" is enabled (Log = 1).
WARNING: if you do not want the
parameters of the CONFIG.INI file to be
modified,
corresponding lines in the file, leaving
only the lines "[Common]" and "Log = 1".
To verify the total credit: open the CT02, insert a
USB stick into the outlet located on the board at the
to the back of the cover and wait until the second beep of
the internal buzzer sounds, indicating the creation
of the "CTLOG.TXT" file.
The file should look as follows, with the total credit
managed by the CT02, as well as the software
version, indicated.
[Log]
Totalizer = 01234567,89 €
Software version = 1.03
Each time a USB stick is inserted, the system will
update the file.
To zero the credit: disconnect the CT02 power
supply; hold down the programming key located at
the bottom right hand side of the board attached to
the CT02 cover; reconnect the power supply and
then wait for the second beep of the internal buzzer
to sound, indicating the modification of the
configuration parameters.
Pag. 6 / 24
amount programmed
T
OTALIZER
a USB stick
you can
with the P0.5
containing the
cancel the
F E D
AVERO LECTRONIC ESIGN