Safety Warning; Disposal Of Product; Compliance With Ec Regulations; Programming - Favero Electronics CT02 Mode D'emploi

ENGLISH

1.5 Safety warning

WARNING:
installed by a qualified technician and in
compliance with the regulations of the
country in which installation takes place.
For installation please see the appropriate
manual provided.

1.6 Disposal of product

Please dispose of your product in a manner most
compatible with the environment and in accordance
with federal or state laws, reusing parts and
recycling components and materials when possible.
When this crossed-out waste bin symbol is attached
to a product it signifies the product should be
disposed of in a separate container from other waste.
The sorted waste collection of the present device is
organized and managed by the manufacturer. Users
who wish to dispose of their present device should
contact the manufacturer and follow the procedure
indicated for separate waste collection. Ensuring
proper sorted waste collection, in accordance with
environmental standards, for the disposal of further
devices helps to protect the environment and the
health of persons from any damaging effects. It also
favors the reuse
Administrative
regulations in effect, will be applied for any improper
or abusive disposal of the product on part of the
holder.

1.7 Compliance with EC regulations

The CTx meets the necessary requirements for
electromagnetic Compatibility
regarding electronic
European regulations:
• 2004/108/EC of 15 December 2004
• 2006/95/EC of 12 December 2006
2 P
ROGRAMMING
The operating
programmed before using the CT02.
Programming takes place by modifying
the configuration
downloaded from the manufacturer's web
site and by inserting the file into the CT02
via a USB key.
For programming, follow the steps below:
• download the "CTCONFIG.INI" file from the
product page of the web site www.favero.com;
• open the "CTCONFIG.INI" file with a double click
and modify the
00182-M07-01-ML User manual CT02
Make sure the
and recycling of
sanctions, in accordance
and
equipment, according
parameters
file previously

programming

parameters
according to your needs. Be sure to follow the
card indications below. To open the file make
CT02 is sure you use a text editor such as "Notepad";
• save the "CTCONFIG.INI" file without modifying
the name or extension;
• open the CT02 cover by unscrewing the four
front screws. Locate the USB outlet found at the
bottom right hand side of the board attached to
the back of the CT02 cover;
• insert the USB stick into the outlet;
• wait for the second beep from the interal buzzer
to sound, which indicates that the modification of
the configuration parameters is complete;
• remove the USB stick and put the CT02 cover
back in place.
materials.
with
Security
to
must be
Pag. 4 / 24
PROG
USB
If service is in use, it will not be possible to
update the paramenters via the USB stick.
Wait until service has been terminated or
hold down the programming key (located at
the bottom right hand side of the board
attached to the cover inside the CT02) for
circa 10 seconds until the second beep of the
internal buzzer sounds, indicating that the
modficiation of the configuration parameters
is complete.
F E D
AVERO LECTRONIC ESIGN