ASCOM Ascotel Office 100 Mode D'emploi page 145

Installation and putting into service
Table/desk or wall installation, as you wish
Table/desk installation
It is easiest to use the charging base as a table/desk unit. Simply place it at the desired
location and connect it.
Wall installation
2. Turn as indicated
1. Push out
and up
Hooks for
wall installation
1. Turn the wall installation hook in the charging base by 180° (as shown in figure).
2. Switch the feet on the underside of the charging base (high feet at bottom of base) so
the charging base hangs parallel to the wall.
3. Drill two holes (5 mm in diameter), spacing them 66 mm apart from each other.
4. Insert the wall plugs.
5. Screw in both screws until the heads are approx. 5 mm from the wall.
6. Mount the charging base in place and then pull down to locate in keyholes.
20BA265311/BO
3. Reinsert
66
9,0 VDC / 400 mA
9,0 VAC / 170 mA
7