Publicité
Installation of the FPV-Head
To replace the sensor unit, turn the head of the camera
until you can see the screws. Remove these four
screws with the appropriate screwdriver.
Carefully disconnect the sensor unit from the plug of the
ribbon cable.
Now connect the ribbon cable of the FPV-head with the
one of the cam as shown on the picture.
Replace the screws at the camera cover instead of at
the camera head. Make sure that the ribbon cable is
not creased!
After you have connected
the ribbon cable, take the
unit you have just removed
from the camera's head and put it to the front of the
FPV head. The ribbon cable has to point in the
direction of the boards recess.
Attention! Inappropriate opening may cause damages on the camera's head and
its connections.
Take time for this work!
At least connect the Servo cables to your RC-
Receiver. Using the FlyCamOne HD V- Eyes you
need to connect the servos to the channels 5 and
6.
The FPV-head is equipped with 4 holes at bottom
and backside in order to be strongly fixed to your
model.
4
Publicité
