Manual Time Setting - Oregon Scientific 30.3016.54.IT Manuel D'utilisation

MANUAL TIME SETTING

In area where reception of the DCF-77 time is not possible, the time can be manually set. The
clock will then be a normal Quartz clock. Once the DCF signal is detected, it will change the
manually set time into the received time. Please preceed the following setting steps at the first
time before using the temperature station.
Hours (flashing)
1. The hour digit in the time section starts flashing. Use the MIN/MAX/+ button to set the
hour.
2. Press the SET button to enter the minutes. The minute digits start flashing.
3. Use the MIN/MAX/+ button to set the minute.
4. Press again the SET button to confirm and enter the Calendar setting mode.
Minutes (flashing)
55