AquaStat SciCan W10000 Série Guide D'utilisation Et D'entretien page 8

Operating Instructions Continued
8. Slide the boiling chamber into the distiller chassis and press firmly to
insure that it is properly placed. It is
important that the boiling chamber be
pressed firmly into the distiller chassis.
It is recommended that you place one
hand on the back of the distiller chassis
and push the boiling chamber into the
chassis with the other hand. To ensure
that a tight electrical connection is made,
press on the base of the boiling chamber
near the start button also.
CAUTION: To prevent personal injury or property
damage, the boiling chamber must be fully
engaged prior to start-up.
9. Press the "start" button at the base of the
boiling chamber.
NOTE: The button will glow when the boiling
chamber is heating, however, the light will go out
and the boiling chamber will stop heating if electrical
power to the boiling chamber is interrupted or
stopped. If this occurs, press the start button again
to restart the distillation cycle.
10. The cooling fan will not start immediately.
A delayed fan startup feature has been included
in your distiller. The fan will start once the boiling
chamber has reached a pre-determined
temperature, approximately 30-40 minutes after
starting the cycle.
NOTE: Do not install the cap onto the water bottle.
The bottle must be left uncapped to allow water to enter
it from the distiller.
11. Make sure that the dispensing valve is securely
tightened onto the water bottle.
Use and Care Guide
Flat edge
Baffle
of baffle
Spout Securing
Nut
Dispensing Valve
Page 6