Audiovox Rampage AA-929 Manuel De L'utilisateur page 3

,
age sensor. In such situations, the level of protection is
minimized and reliant strictly on the vibration detector. It
may be necessary to increase the sensitivity of the vibra-
tion sensor. To do so see the section on adjusting the
shock sensors for optimum results.
WHITE LOOP:
The White loop wire controls the voltage sensors arming
delay. Vehicles with circuits that remain on after the igni-
tion switch is turned off will require a delay before arming.
Cutting the white loop wire will delay the voltage sensor's
arming delay from 3 seconds to 5 minutes. This addi-
tional delay will allow any active circuit in the vehicle to
turn off before the voltage sensor is capable of detecting
voltage drops. This will allow you to arm the unit immedi-
ately when exiting the vehicle, once the vehicles electrical
circuit stabilizes, the alarm will fully arm sometime later.
PROGRAMMING THE TRANSMITTERS:
Your AA-929 Security System will learn up to two Audiovox
code learning transmitters. To program the transmitters,
disconnect power to the alarm for 10 seconds. Reconnect
power and within 10 seconds, press button #1 of the first
transmitter to be programmed. The siren will chirp indicat-
ing the transmitter has been learned. Within 5 seconds of
the first learned transmitter, press button #1 of the second
transmitter to be programmed. The siren will chirp indicat-
ing the second transmitter has been learned.
! -
NOTE: If the vehicle battery is disconnected, or the alarm loses
power, the transmitters WILL NOT remain in memory.
In such instances, re-programming the transmitters is
necessary to operate the alarm. To re-program the
transmitters, repeat the above procedure.
OPERATING YOUR SYSTEM:
ARMING:
1. Exit your vehicle, and close all entry points.
2. Press button #1 of your keychain transmitter 1 time. The
siren will emit a single tone indicating that the system is
armed.
NOTE: Pressing the arming button twice within 3 seconds will
allow the unit to arm without the shock sensor. This
will be indicated by a single chirp tone followed by a
single higher pitch chirp tone. When operating in this
mode, the only detection means will be the voltage
sensor. The next normal arming of your system will re-
instate the shock sensor.
DISARMING:
1. As you approach your vehicle, press button #1 of your keychain
transmitter 1 time. The siren will emit two chirps indicating
that the system is disarmed. You may now enter and oper-
ate your vehicle in a normal manner.
NOTE: If you heard four chirp tones upon disarm, this indicates
that the system had been triggered in your absence.
Carefully inspect your vehicle for break in or physical
damage.
-2-
http://www.msvmaster.lv