Solving Problems - Lacor 69302 Instructions D'utilisation Et D'entretien

Problems
Machine does not work
Water temperature does not
increase
Water goes on heating after the
set temperature is reached.
E1 appears on the display.
Machine plugs in and turns on, but
no display in the LCD.
The pump is noisy
48

SOLVING PROBLEMS

Raisons
1.- Power cord is not plugged
in well.
2.- Power button is off.
3.- Problem from the power
supply.
1.- Set temperature below or
close to the water
temperature.
2.- Set heating time is too short.
1.- Program is wrong.
2.- Temperature sensor is invalid.
3.- The circulator does not rotate.
1.- Machine does not be put into
water.
2.- Water level is too low.
1.- Power button is off.
2.- Machine is wrong.
1.- Dirt in the pump
2.- The main body is not
assembled correctly
Solution
1.- Plug in, turn on the machine.
2.- Turn on the power switch.
3.- Check if the other Machines
work normally.
1.- Check the setting.
2.- Prolong the heating time.
1.- Restart the power switch.
2.- Repaired by the specialist.
3.- Repaired by the specialist.
1.- Put the machine into water
and restart the power switch.
2.- Add water, make sure the
water level is between the
MIN and MAX line.
1.- Turn on the power switch.
2.- Repaired by the specialist
1.- Clean the machine and the
pump as instructed in the
manual chapter Cleaning or
ask a specialist to clean them.
2.- Read the instructions in the
section on cleaning and
maintenance