Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Batteries must be disposed separately!
•
For information about recycling, please contact your local authorities or your retail dealer.
•
When the appliance has reached the end of its service life store it away from the reach of chil-
dren until disposal.
Product description
1
A Dust compartment
B Dust filter
C Unlocking button
D Charging indicator
E ON / OFF switch
Installing the wall holder
Your vacuum cleaner is supplied with a special wall holder.
2
When installing the wall holder, choose a position near (at the side of) a mains
power socket, which must not be in the open air or in a damp room. To install the
wall holder, hold it (with the charging plug at the above) against the wall in the intended
position and transfer or mark the mounting holes with a sharp pencil. Take care to ensu-
re that the holder is vertical and that the holes are not positioned over any electrical
cables or water pipes which could be punctured.
After drilling the holes and inserting the wall plugs, install the screws in the plugs until the
screw heads are approx. 3 mm from the wall.
Now hook the holder onto the screws and push downwards as far as it will go. Once the
two screws are located in the slots, tighten the screws to secure the holder.
Charging the battery
The NiMH-battery (nominal voltage 7,2 V – charging capacity max. 1300 mAh) of
3
the battery vacuum cleaner is charged only partially and must be recharged
approx. 20-24 hours before use. Plug the charging plug and the vacuum cleaner
into the wall holder and the power supply/charger into a socket. Correct char-
4
ging is indicated by the charging indicator lighting up. The indicador lights up
permanently, i.e. it does not cut-off automatically. It is normal for the unit to beco-
me warm during charging. It is advisable to recharge the battery vacuum cleaner after
each time it is used at a longer time so that it is fully charged and ready for the next
use. Avoid a total discharge of the batterry. This could damage it and reduce the maxi-
mum charging capacity, i.e. shorten the running time
Note:
The ON / OFF sliding switch must be switched off while charging. The appliance must
not be charged at temperatures below 0°C or above 40°C. If the appliance will not be
used for a prolonged period (approx. 6 weeks), it is advisable to disconnect the charger
from the power socket. Store the appliance in a cool place and charge it every six
months at least.
F Motor with Battery module
G Wet nozzle
H Filter holder
I
Crevice nozzle
9
Publicité
Table des Matières
