Opale-Paramodels JUMPBOX Manuel D'utilisation page 10

Then hold the pod with 2 x M3x8 CHC screws,
2 x large M3 washers and 2 x M3 nuts.
With pliers, bend the end of the pin in a S
shape of a width of 5mm
Place the pin on the servo horn, at a distance
of 10mm from the rotating axis.
Then add the servo horn on the servomotor.
Connect the servomotor on you receiver and
adjust the end of position to its maximum in
order to have the servo horn in lock position.
Cut off the surplus of the pin in order to have
a length of 10mm remaining.
In unlock position, the pin must not exceed
the plate to allow the dropping of your RC
skydiver.
O pal e - Pa ramo del s. co m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
10
contact@opale-paramodels.com +33(0)981 144 387