Publicité
Montageanleitung / Assembly instruction / Notice de montage
SR mit TS-61 / 51 B
SR with TS-61 / 51 B
SR avec TS-61 / 51 B
Assembly for active leaves on the left is described below. For active leaves on the right, please proceed accordingly.
Attach drilling template and choose corresponding drill holes depending on mounting situation (direct mounting,
mounting with standard profile or mounting with adaptor plate). Drill holes.
Direct mounting
1a
Screw on door closer mounting plates.
Mounting with standard profile
1b
Screw on standard profiles (optional), shorten if necessary
Mounting with adaptor plate
1c
Screw on adaptor plate (optional), shorten if necessary
Direct mounting
2a
Mount active leaf slide rail and passive leaf slide rail directly.
Mounting with standard profile
2b
Mount active leaf slide rail and passive leaf slide rail onto standard profile.
Mounting with adaptor plate
2c
Mount active leaf slide rail and passive leaf slide rail onto adaptor plate.
Connect lever arms to door closer
3
Close closing speed valve
4
Open speed valves. Close doors.
Set closing speed.
5
Set closing force.
6
Set latching speed.
7
Set back check.
8
Determine dimension x in line with drawing
9
x + 28 mm and trim
Push coupling sleeves as depicted onto the connecting rod
10
rod between the rod ends
the screws of the coupling sleeves have to point downwards.
Determine dimension y acc. to drawing
11
the cover profile
2
Attach cover profile to mounting profile
12
Functionality test SR
Open both doors approx. 60°, active leaf has to remain open. Passive leaf closes. Active leaf is only allowed to
close if the passive leaf reaches a closing angle of approx. 30°.
Attach nylon clips
13
Clip on covers for drill holes in slide rail.
14
(DIN links / DIN rechts spiegelbildlich)
(DIN left / DIN right mirror image)
(DIN gauche / DIN droite inverser l'illustration)
. Fit door closer
1
. Guide the lever arm in the direction of the slide rail
1
.
2
. Push the coupling sleeves over the rod ends and tighten grub screws
3
. Cut to length the U-cover profile to dimension y - 8mm and deburr
1
.
, adjust it and fix it
1
. Clip on U-Cover
and pinion cover
1
2
.Screw on door closer mounting plates
1
.Screw on door closer mounting plates
1
.
2
. Cut connecting rod to length in line with said dimension
1
. Turn the connecting rod by 90°
1
.
2
.
3
.
2
.
2
and connect to the slide rail .
2
.Push connecting
2
. Attention:
4
3
9/10
Publicité
