Westfalia X-SAW II Mode D'emploi Original page 21

▪ Do not attempt to use the charger with any batteries other than those
supplied. Keep the battery charger clean; foreign objects and dirt can cause
a short circuit and block the ventilation holes. Failure to follow these
instructions may cause overheating or fire.
▪ Allow batteries to cool for 15 minutes after charging or heavy use. Failure to
follow these instructions may cause overheating or fire.
▪ Recharge only with the charger specified by the manufacturer. A charger
that is suitable for one type of battery may create a risk of fire when used
with another battery pack. Charge the lithium-ion battery only with the
supplied charger or a charger specifically designed for this item.
▪ Use the machine only with specifically designated battery packs. Use of any
other battery packs may create a risk of injury and fire.
▪ If the power cord of the charger is damaged, it must be replaced by the
manufacturer, an authorised service workshop or a specialist before use.
▪ Keep the battery out of reach of children.
▪ When not in use batteries should be stored at room temperature (approx.
20° C).
▪ When battery is not in use, make sure the battery cannot be shorted
accidentally. Keep the battery clean at all times. Keep it away from other
metal objects, like paper clips, coins, keys, nails, screws or other small metal
objects that can make a connection from one terminal to another. Shorting
the battery terminals together may cause burns or a fire.
▪ If used incorrectly, liquid may leak from the battery. Avoid contact with it. In
case of accidental contact, rinse with water. If the liquid gets into the eyes,
seek additional medical attention. Leaking battery fluid may cause skin
irritation or burns.
▪ Protect the battery and charger from moisture. Do not operate the charger
outdoors.
▪ When the charger is not in use, unplug it from the wall socket before
cleaning and servicing.
▪ Take special care of the battery. Avoid dropping it onto
any hard surface and do not subject it to pressure or any
other form of mechanical stress. Keep the battery away from extreme heat
or cold. Do not open, disassemble, crush, heat above 60° C or incinerate. Do
not dispose of in fire or similar.
▪ Only use original accessories and original spare parts.
▪ In the interest of your own safety, do not modify the multi saw in any way.
21