Operating; Items Supplied And Packaging - Medisana HP 622 Mode D'emploi

GB

2 Operating

Thank you very much for your confidence in us and congratulations!
With this Heat pad for neck and shoulder you have purchased a quality product by
MEDISANA. To ensure the best results and long-term satisfaction with your Heat pad
for neck and shoulder, we recommend that you read the following operating and
maintenance instructions carefully.

2.1 Items supplied and packaging

Please check first of all that the unit is complete and is not damaged in any way. If in
doubt, do not use the appliance. Send it to a service point.
The following parts are included:
• 1 MEDISANA Heat pad for neck and shoulder HP 622 with removable control unit
• 1 Instruction manual
The packaging can be reused or recycled. Please dispose properly of any packaging
material no longer required. If you notice any transport damage during unpacking,
please contact your dealer without delay.
WARNING
Please ensure that the polythene packing is kept away from the
reach of children! Risk of suffocation!
2.2 Operation
You can use the MEDISANA Heat pad for neck and shoulder HP 622 to gently warm
and relax these parts of the body. Using the heat pad stimulates blood circulation in
hardened muscles and helps you to relax after a strenuous day. The heat pad features
an electric temperature control that regulates the temperature according to the chosen
setting.
Make sure, the connection cable of the control unit is properly connected to the plug of
the heat pad. Plug the unit into the mains outlet and move the slider control from position
0 to position 1. The power LED will light up. When switching up and down the different
levels, the indicator lamp flashes twice briefly and then comes on permanently.
After a few minutes you will be able to feel the pad getting noticeably warmer. If you
require a higher temperature setting, move the switch to the next positions 2, 3, 4, 5 or the
maximum heat setting, position 6. If the heat pad gets too hot for you, move the slider
back to position 5, 4, 3, 2 or 1. After a short time, the heat pad will cool down.
Level 2 - 6 of the device is intended for heating up, only level 1 is for continuous
operation.
To switch the unit off, move the switch back to position 0. The power LED will go out,
indicating that the unit is switched off. Unplug the unit from the mains outlet.
Move the switch to position 1 for any continuous use. The heat pad will switch off
automatically after approx. 90 minutes of continuous use. To switch it back on again,
move the slider switch to position 0 and then back to the desired heat setting. Unplug
the unit from the mains outlet once you have finished using it.
12