Preparation And Setup; Working With The Battery-Powered Clipping Machine Fav5 Cl, And The Charger Gt203/ Li-Ion Battery Gt201; System Set-Up; Connecting The Accessories - Aesculap Suhl FAV5 CL Mode D'emploi

3.

Preparation and setup

Non-compliance with the following instructions will
preclude all responsibility and liability in this respect
on the part of Aesculap.
When setting up and operating the product, adhere
to
– national regulations for installation and opera-
tion,
– national regulations on fire and explosion protec-
tion.
– operating advisories according to IEC-/VDE regu-
lations.
Fire and explosion hazard!
Do not operate the product in
explosion-hazard areas.
DANGER
Malfunction of, or damage to the
product caused by improper setup!
Do not expose the product to
CAUTION direct sunlight or moisture.
Do not cover the ventilation
slots of the product.
Connect the product to the
specified voltage of 100 V to
240 V/50 Hz to 60 Hz.
Ensure that the mains power
socket used for supplying the
product is freely accessible.
4. Working with the battery-
powered clipping machine
FAV5 CL, and the charger
GT203/Li-ion battery GT201

4.1 System set-up

4.1.1 Connecting the accessories

Combinations of accessories that are not mentioned in
the present instructions for use may only be employed
if they are specifically intended for the respective
application, and if they do not compromise the perfor-
mance and safety characteristics of the products.
Please contact your B. Braun/Aesculap Partner or
Aesculap Technical Service with any inquiries in
this respect, see Chapter Technical Service.
5