Functional Description - Makita 4100NH Manuel D'instruction

19. Do not stop the wheel by lateral pressure on
the disc.
20. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
21. The tool must be used only for dry cutting. DO
NOT use water.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting the depth of cut
007691
Loosen the wing bolt on the depth guide and move the
base up or down. At the desired depth of cut, secure the
USD201-2
1. Wing bolt
2. Base
1
2
base by tightening the wing bolt.
CAUTION:
After adjusting the depth of cut, always tighten the
•
wing bolt securely.
Sighting
007693
Align the edge of the front of the base with your cutting
line on the workpiece.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1
007692
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
push in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
5
1. Switch trigger
2. Lock-off button
2