Safety Information; How To Install - edenox APE-902-C HC Mode D'emploi

Armarios refrigerados para exposición con cabezal iluminado
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

Safety Information

• Position the cabinet on a flat and stable surface.
• A qualified technician should carry out installation and any repairs if required.
• Do not remove any components or service panels on this product.
• Consult Local and National Standards to comply with the following:
- Health and Safety at Work Legislation
- Fire Precautions
- Building Regulations
• Never use pressure washers to clean the appliance.
• Don't use the appliance outside.
• Don't use this appliance to store medical supplies.
• Don't use electrical appliances inside the appliance (e.g. heaters, ice-cream makers etc.).
• Don't allow oil or fat to come into contact with the plastic components or door seal.
Clean immediately if contact occurs.
• Never store products on top of the appliance.
• Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the
refrigerator.
• Always carry, store and handle the appliance in a vertical position and move by holding the base
of the appliance.
• Always switch off and disconnect the power supply to the unit before cleaning.
• Keep all packaging away from children. Dispose of the packaging in accordance with the regula-
tions of local authorities.
• If the power cord is damaged, it must be replaced by a qualified technician in order to avoid a
hazard.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilites, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety
• Children should be supervised to ensure that they do not play with the appliance
About this manual
Please take a few moments to carefully read through this manual. Correct maintenance and opera-
tion of this machine will provide the best possible performance from your product.

How to install

Important: If the cabinet has not been moved or stored in an upright position, let it stand upright
for approximately 12 hours before operation. If in doubt allow the appliance to stand.
1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings
are thoroughly removed from all surfaces.
2. Maintain a distance of 20 cm between the unit and walls or other objects for ventilation.
Increase this distance if the obstacle is a heat source.
Important : Before using the appliance for the first time, clean the shelves and interior with
soapy water.
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ape-902-cc hc

Table des Matières