Sharp KH-6VX09FS00-EU Guide D'utilisation page 37

pressing , a Cooking Zone Indicator will
flash for the timer it is assigned to. If no
Cooking Zone Indicator flashes, the minute
minder timer value will be shown on the
Timer Display.
All heater timers can be removed by
switching the appliance to S-Mode using
, however this will have no effect on the
minute minder timer which will continue
counting down.
To remove a timer in Operation Mode,
first select the timer using the Activate/
Deactivate Timer button until the desired
timer is displayed on the Timer Display. It
can then be removed in two ways:
• Decrease the value by using the slider
button until "00" is shown on the Timer
Display
• Press the right and left sides of the
slider button simultaneously until "00" is
shown on the Timer Display
Once a timer reaches "00", the level of
its corresponding heater will also set to
"0". The end of both the heater timer and
the minute minder timer is indicated by
a buzzer sound, this can be stopped by
pressing any button.
Key Lock
The key lock function is used to set 'safe
mode' on the appliance and can only be
used in Operating Mode (B-Mode). The lock
function becomes active when the Key Lock
button is pressed for at least 2 seconds.
This operation is acknowledged by a buzzer
and the Key Lock Indicator will flash to
indicate the heater will be locked.
If the heater is locked, it will only be
possible to switch the appliance off by
pressing , all other buttons are blocked
and it will not be possible to make any
adjustments by pressing the buttons. If any
other button is pressed in the lock mode,
the buzzer will sound and the Key Lock
Indicator will flash.
Only the switch-off operation by pressing
is possible. However, if the appliance is
switched off, it can not be restarted again
without being unlocked.
Press to deactivate the Key Lock
function, the Key Lock Indicator will
disappear. The hob controls can now be
operated as normal.
Child Lock
The Child Lock function is used to lock
the appliance in a complicated multi-step
process. Child lock (and unlocking) is only
available in the S-Mode.
First, must be pressed until the buzzer
sounds, then simultaneously press the right
and left sides of the slider button for at least
0.5 seconds, but no longer than 1 second.
Following this, press the right side of the
slider button only to activate the child lock.
All four heater displays will show "L" as
confirmation.
If the minute minder timer is still running,
it will proceed until "00" is reached and
the timer will sound. After confirmation of
timer completion, the appliance will be fully
locked. None of the buttons can be used as
long as the appliance is locked.
Child lock can be deactivated by pressing
until the buzzer sounds. Then press
the left and right sides of the slider button
simultaneously for at least 0.5 seconds,
followed by pressing the left side of the
slider button only. As confirmation for
successful unlocking, "L" will no longer be
displayed.
Stop & Go
The Stop & Go function is used for pausing
the operation of the heaters during use. If
the Stop & Go button
the heaters are in operation, all the heaters
will switch off. Pressing
time, will switch all the heaters back on.
Touch Control Safety Functions
The following safety functions are available
to avoid unintended operations.
Sensor Safety Cut-Off
Button monitoring is included to prevent the
EN - 15
is pressed while
for a second