Control Panel - EUROM LO50 Manuel D'utilisation

The LO70P is fitted with an in-built drainage pump. When the collected water has reached
pump level, the pump comes on automatically and pumps the water away, up to max.
4.7m high.

CONTROL PANEL

1. ON/OFF button
2. 'Humidity up' button
3. 'Humidity down' button
4. Humidity display
5. 'ON' light
6. LO50: Watertank full
You switch the device on and off with the ON/OFF button.
Every time you press the buttons 'humidity up or 'humidity down, you set the desired air
humidity level1% higher or lower. If you depress the button for longer than 1.5 seconds,
the set humidity will increase/decrease at a rate of 5 points per second.
The devices have a 'ventilator' signal light that comes on when the internal ventilator is
working. This always works while the device is operating, unless it is defrosting. The
LO70P also has a 'defective pump' signal light. The device will stop operating. Consult
your service point if this light comes on.
All devices also have an hour counter that counts the total number of hours your device
has been operating (in units of 10 minutes).
STARTING AND OPERATING
Check that the socket, to which you are connecting the dehumidifier, provides the voltage
as indicated on the specification plate: 220/240V-50Hz.
L070 and LO120: Check that the drainage hose is correctly connected and is able to drain
properly into the appropriate waste outlet. The drainage hose on the LO70P may also be
positioned on an upwards incline (max. 4.7m).
Insert the plug into the socket; the device will beep.
Press the ON/OFF button. The ON light will come on and the display will show the factory
setting for humidity: 60%.
17
LO70P: Defective pump
LO70 & LO120: --
7. Defrosting light
8. Fan
9. Hour meter