Important Warning - Silhouette DKC055D1SSPRO Manuel Du Propriétaire

Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING: CO
2
CO Cylinders, when charged, contain high
2
pressure compressed gas which can be hazardous
if not handled properly. Read and understand the
following procedures for CO
installation:
1. Always check the D.O.T. (Department of
Transportation) as well as the T.C. (Transport
Canada) test date located on the neck of the
cylinder before installation. If the date is older
than fi ve years, do not use! Return the gas
cylinder to a gas supplier for re-certifi cation
(service charges may be applicable).
2. Always connect a CO
regulator. Failure to do so could result in an
explosion which can possibly result in death or
injury when the cylinder valve is opened.
3. Always follow correct procedures when cylinders
are changed as per local codes.
4. Always secure a CO
"upright" position.
5. Always keep a CO
heat. Store extra cylinders in a cool place
(preferably 70°F/21°C or less).
6. Always ventilate and leave the area immediately
after any leakage of CO
7. Never drop or throw a CO
8. Never connect a keg without at least one safety
pressure release:
• One at or on the CO
• One at or on the product container coupler
in the pressure gas line.
CO
2
If it becomes diffi cult to breathe or your head
starts to ache, abnormal concentrations of
carbon dioxide (CO
CLOSE THE VALVE ON THE CO
VENTILATE AND LEAVE THE ROOM
IMMEDIATELY!
CAN BE DANGEROUS!
cylinders before
2
gas cylinder to a
2
gas cylinder in an
2
gas cylinder away from
2
.
2
cylinder.
2
regulator.
2
WARNING
) may be present in the
2
area.
CYLINDER,
2
SAVE THESE INSTRUCTIONS!
1. Pressure gauge dial
2. Pressure relief ring
3. Open/Close valve
Ensure the CO tank is empty before courier or 3
2
party transport.
DANGER - A charged CO
pressure. Uncontrolled release of pressure is
extremely dangerous. The instructions below use the
regulator to control the release of this pressure in a
safe manner. Do not bypass the regulator.
1. Open valve by turning counter-clockwise. The
pressure gauge dial will show a value if tank
contains pressure.
2. Pull pressure relief ring. Released gas should be
heard.
3. Continue to hold the pressure relief open until
the tank is empty and the pressure dial reads
zero.
4. Release the pressure relief ring.
5. Close valve by turning clock-wise.

IMPORTANT WARNING

Beer is easily available with Danby's Keg Cooler,
however, it is not intended to be available to
people under the legal age to consume beer.
Danby does not assume liability for the unlawful
use or consumption of the beer.
PLEASE DRINK RESPONSIBLY AND
DON'T DRINK AND DRIVE!
3
1
3
2
tank is under extreme
2
rd