Silhouette DKC055D1SSPRO Manuel Du Propriétaire page 10

INSTALLATION INSTRUCTIONS
Opening the CO Cylinder Main Valve
2
To begin the fl ow of CO
top of the Co cylinder. The pressure gauge on the
2
regulator will begin to climb.
Turn the CO shut off valve on the regulator to the
2
open position to allow CO
line and into the coupler.
Adjusting the CO Regulator
2
The pressure gauge monitors the air pressure inside
the lines and should be adjusted to read between
8-12 PSI.
The pressure can be adjusted at any time, as
needed. If the beer is very foamy, try turning the PSI
down. If the fl ow of beer is very weak, try turning
the PSI up.
After making any adjustment to the PSI, wait 5-10
minutes before attempting to pour another beer to
allow the pressure inside the lines to equalize.
• To increase the PSI, turn the adjustment screw
clockwise.
• To decrease the PSI, turn the adjustment screw
counter-clockwise.
Checking Connections For Leaks
Weak connection points can allow the escape of
CO or allow air into the system, both of which can
2
cause weak beer fl ow or excessively foamy beer.
Leaking connections can sometimes be identifi ed by
hissing at the connection points. They can also be
identifi ed by spraying water on the connection point
and watching for bubbles to form.
If a leaking connection point is found, it should be
rectifi ed before attempting to use the system again.
Turn off the fl ow of CO
or washers in the connection points. Tighten all nuts
with a wrench. Test the system again before using to
ensure all connection points are secure.
, turn the valve on the
2
to travel through the air
2
and replace any gaskets
2
Completed Assembly
1
1. Pressure Regulator
2. C0 Tank
2
3. Colored CO Air
2
Line Hose
4. Faucet Assembly
5. Faucet Tower
6. Clear Hose with
Wing Nut
7. American Sankey
Coupler
8. Keg
CONVERTING TO A REFRIGERATOR
This appliance can be converted to a refrigerator if
desired.
1. Disconnect and remove the keg, the coupler,
the regulator and the CO
refrigerator cabinet.
2. Remove the faucet tower, the guard rails and the
drip tray from the top of the refrigerator cabinet.
3. Replace the cover for the opening on top of the
refrigerator cabinet.
4. Install the provided wire shelves in the
refrigerator cabinet.
5. Set the control panel to the desired temperature.
Allow the appliance to remain empty for a
minimum of two hours before stocking with
food or beverage items to ensure it reaches the
desired temperature.
9
2
6
3
7
8
cylinder from the
2
4
5