Lubricants For Screw Drives And/Or Profiled Rail Bearings - NTN-SNR AXC Série Mode D'emploi

AXC linear axes feature lubricating nipples on both sides to guarantee the highest possible level of
accessibility. AXDL linear axes feature lubricating nipples on both front sides of the table. This means that
the quantities listed above may only be applied into the respective lubricating nipple on one side of the axis
per lubrication interval.
Relubrication option for linear axes with toothed belt drive. Lubrication point F for axis type AXC120 with ball
screw drive and roller guide.
The given factor is to be applied as follows:
AXC series: For incline mounting position and initial relubrication overhead mounting.
AXDL series: For overhead and incline mounting position for initial relubrication.
We recommend a relubrication interval of 5,000 km or once per year.
Oil to use: ISO- VG 460.
Lubricants for screw drive and/or profiled rail bearings
The NTN-SNR lubricant LUB HEAVY DUTY is used under normal conditions. Special requirements and
unusual environmental conditions require the use of a suitable lubricant. When relubricating with other
lubricants, the compatibility of the lubricants is to be tested.
Description Type of oil,
Consistency
builder
Mineral oil,
High-pressure
additive lithium soap
LUB HEAVY
DUTY GREASE
Paraffin mineral oil /
aluminium -
complex soap
LUB
FOOD GREASE
Synthetic
hydrocarbons -
Oil / special -
Klübersynth
calcium soap
BEM34-32
Synthetic
hydrocarbons - oil /
ester oil / aluminium -
Klübersynth
complex soap
UH1 14-151
* This lubricant has been registered as a H1 product, i.e. it was developed for occasional, technically unavoidable contact
with food. Experience has shown that the lubricant can also be used for corresponding applications in the pharmaceutical
and cosmetics industry under the conditions as specified in the product information. However, there are no specific test
results, e.g. with regard to bio-compatibility, as may be required for pharmaceutical applications. Thus corresponding risk
analyses in this field are to be carried out by the plant manufacturer and operator before application. Where necessary,
steps are to be taken to exclude any risks to health or injuries. (Source: Klüber Lubrication)
NLGI Walk Basic oil
class penetration viscosity
DIN DIN ISO DIN51562
51818 2137 at at 40°C
25°C [mm /s]
2
[0,1 mm]
2 150
2 265... 295 ca. 240
2 265... 295 ca. 30
1 310... 340 ca. 150
27
Density Temperature Properties
[kg/m ] range
2
[°C]
900 -30...+110 Normal conditions,
standard
lubrication
920 -30...+110 Good corrosion
protection, very
good adhesion,
high water-
resistance, NSF
H1-registered*
890 -30...+140 Specially
pressure-resistant,
good wearing
protection, good
ageing resistance,
low starting torque
920 -45...+120 Good corrosion
protection,
age-resistant,
water-resistant,
NSF H1-
registered*
Applications
General machine
construction
Food
industry
Clean room
applications
Pharmaceutical
industry / food
industry