Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The sealing strip has a trapezoidal cross section. When applying the new sealing strip, it must be ensured
that the broadest surface is on the bottom. Applying gentle pressure by hand or with a smooth object free
of sharp edges, latch the belt into place in the intended slot so that it is flush with the upper profile edge.
Mounting can also be performed in the reverse of disassembly order.
Masking belt replacement – AXDL series
First loosen and remove the belt deflection (b) together with the lubricating nipple (f) and the disc (e).
The attachment rail (d) can then be removed by unscrewing the retaining screws (c). The old masking belt (a)
can now be removed and replaced with a new one.
Mounting can also be performed in the reverse of disassembly order.
Important note: The new sealing strip should be tightened in a way that it does not drag on the table.
This can be checked with inspection bore holes in the slot bottom (sealed with plastic plugs).
b
c
d
e
f
a
20
Publicité
Table des Matières
