Hitachi C 10FSH Instructions De Sécurité Et Mode D'emploi page 25

Crown molding Vise Ass'y
(optional accessories)
6mm Knob Bolt
V-Groove
Groove
Fence
6mm wing bolt Crown molding
Crown molding Stopper (L)
Crown molding Stopper (R)
(optional accessories)
Fig. 46-b
WARNING:
Always firmly clamp or vise to secure the crown molding to the fence; otherwise the
crown molding might be thrust from the table and cause bodily harm.
Do not bevel cutting. The main body or saw blade may contact the sub fence, resulting
in an injury.
CAUTION:
Always confirm that the motor head (see Fig. 1) does not contact the crown molding
vise ass'y when it is lowered for cutting. If there is any danger that it may do so,
loosen the 6mm knob bolt and move the crown molding vise ass'y to a position
where it will not contact the saw blade.
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT
EDGE against the crown molding Stoppers as shown in Fig. 46-b.
Adjust the crown molding Stoppers according to the size of the crown molding.
Tighten the 6mm wing bolt to secure the crown molding Stoppers.
Refer to the lower table for the miter angle.
For inside corner
For outside corner
Use the sub fence (A) (optional accessories) to secure the crown molding more firmly. (see Fig. 15)
11. Groove cutting procedures
Grooves in the workpiece can be cut as indicated in Fig. 47 by adjusting the 8mm depth adjustment
bolt.
Cutting depth adjustment procedure:
(1) Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand.
(2) The crown molding vise (B) (Optional accessory) can be
mounted on either the left fence (Fence (B)) or the right fence
(Fence (A)). It can unite with the slope of the crown molding
and vice can be pressed down.
Knob
Then turn the upper knob, as necessary, to securely attach the
crown molding in position. To raise or lower the vise assembly,
first loosen the 6mm knob bolt. As shown in Fig. 46-b, the vise
shaft has three locking grooves into which the tip of the 6mm
wing bolt is designed to fit in order to lock the screw holder in
the desired position.
To ensure that the tip of the 6mm wing bolt is properly aligned
with the desired locking groove on the vise shaft, simply align
the upper surface of the fence to either of three v-grooves on
the vise shaft surface or to the lower surface of the screw holder.
Therefore, the vise assembly can be attached in eigher of three
positions to ensure proper height adjustment.
After adjusting the height, firmly tighten the 6mm wing bolt;
then turn the upper knob, as necessary, to securely attach the
the crown molding in position. (see Fig. 46-b)
Position in Fig. 34
1
2
3
4
Cut grooves with saw blade
a
b
Fig. 47
Miter angle
Right 45° Save the right side of blade
Save the left side of blade
Left 45°
Save the right side of blade
Right 45° Save the left side of blade
8mm Depth
Adjustment Bolt
b
Bottom Line of
the Groove
Fig. 48
English
Finished piece
8mm Wing Nut
Gear Case
Turntable
25