Refco Apex M2 Mode D'emploi page 6

• If the correct filling quantity has been reached close all valves.
• After the filling process check the pressure on the pressure and compound side of the
unit. You may use the flare cap provided.
Finishing
• Disconnect all hoses from the system
• Open valves (6+7)
Service of manifold:
• The charging hoses must be checked and clean of oil residue before each use. A visible
control is also necessary to ensure that the hoses and the connection are undamaged and
tight.
• The seals and gaskets of the manifold are parts of use and must therefore be replaced
from time to time. The manifold must be tested regularly to ensure the valves are tight.
• If a manifold shows to be leaking, the pistons of the valves can easily be changed and
are available as a spare part. Please refer to the manifold accessory section of the REFCO
catalogue.
• If the sight glass is leaking a replacement kit is available. To change the sight glass
a special tool is necessary (M4-6-11-T, Part No. 4493169) which is also available from
REFCO. Replace and tighten the new sight glass carefully in order to prevent damaging
the glass.
• To change the valve core on models with t-style or vacuum gauge connection, use a
valve core screw driver A-32000 from REFCO.
• After changing spare parts on the manifold it is absolutely necessary to test
the manifold for tightness before the next use.
Further accessories and charging hoses for REFCO manifolds can be found in the REFCO
catalogue or on the web www.refco.ch.
Disposal of manifold:
• Dispose of the manifold according to the rules and regulations of the country of use.
Spare Parts for manifolds:
Knob blue + red
Replacement valves / 2 pieces
Valve seat assemblies / 4 pieces
Sight glass set
Key for manifold
Sight glass
Multi Case
M2-7-SET-B+R
M2-10-95-R/2
M4-6-04-R/4
M4-6-11
M4-6-11-T
M4-6-15
Part No 4687079
Part No 4687104
Part No 4687093
Part No 4491018
Part No 4493169
Part No 4666106