Trouble Shooting - Metabo KG 80/16 Notice D'utilisation Et D'entretien

5.2 Trouble shooting

Trouble shooting Remedy
Faults and possible causes
A. Air escapes between lid and housing:
O-rings damages or soiled Clean or replace O-rings,
tighten screws fully
B. Fasteners are not driven all the way in:
Working pressure too low. ncrease air pressure in 0.5 bar increments,
until fasteners are properly driven.
Cross section of air hose too small.
Min. 6 mm inner diameter required.
Tool without lubrication Clean parts and lubricate.
C. Fasteners are driven too far into the material
Working pressure too high.
Reduce working pressure in
steps of 0.5 bar.
D. Fasteners project or are bend:
Tool not held down firmly enough.
Hold down tool more firmly or increase
working pressure, if necessary.
11