2. Connect the automatic connector to the power cable:
CAUTION: USE ONLY A CABLE 3G1,5RNF
- Connect the earth, neutral and phase cables as shown on the connector and close it again
- Do not leave bare wires coming out of the connector.
3. Screw back the cover.
USE OF REMOTE CONTROL FOR HEADLAMPS WITH MICROWAVE DETECTOR
3.
ON/OFF :
Press the on-off button to switch the light on
permanently or to switch it off.
Detection area. Press to set the
detection range to 50 % or 100 %.
Daylight threshold. Press to set the
threshold to 2, 10, 50 lux or
disabled. If disabled,
Distribué par / Distribuito da / Distributed by NETELEC SRL FR - rue Philemon Laugier - 83400 Hyeres les Palmiers
the light will switch on after motion
detection, regardless of the ambient light.
Hold time. Press to set the hold time
to 5 s, 1 min, 5 min or 10 min.
Press to reset to factory settings
RESET :
(100 % detection range, 5 s hold time,
daylight threshold disabled).
Note: Works with 1 supplied CR2025 battery