Description (Fig. A); Cleaning And Maintenance - König CSFILMSCAN100 Manuel De L'utilisateur

CSFILMSCAN100
Film scanner

Description (fig. A)

The film scanner is a device to scan negative film or
positive film into a digital format.
1. Film scanner
2. Accessory slot
3. Glass plate
4. Scan button
5. USB port
6. Negative film holder
7. Positive film holder
8. Cleaning brush
9.
USB cable
Installation
Before connecting to the PC for the first time,
install the NimoFilm software.
1. Insert the CD into the CD-ROM drive.
The installation wizard appears.
2. Click "NimoFilm" to start the installation.
3. Select the setup language.
4. Click "Next".
5. Select the installation folder.
Default folder: "C:\Program Files\Mysher".
6. Repeatedly click "Next" until the installation is
completed.
7. Click "Finish".
8. Use the USB cable to connect the device to
the PC.
• Move the accessory
through the accessory slot.
Accessories:
- Negative film holder
- Positive film holder
• Press the button to scan
negative film or positive
film into a digital format.
• Use the USB port to connect
the device to the PC.
• Use the negative film holder
to scan negative film.
• Use the positive film holder
to scan positive film.
• Use the cleaning brush to
clean the glass plate.
•
Use the USB cable to
connect the device to
the PC.
5 5
Use
Negative film holder (fig. B1)
Refer to the illustration to scan negative film using
the negative film holder.
Positive film holder (fig. B2)
Refer to the illustration to scan positive film using
the positive film holder.
Operation sequence
1. Connect the USB cable to the scanner and
the PC.
2. Open the NimoFilm software.
3. Click "Capture" on the menu bar to show the
the "Photo Preview" window.
4. Put the negative film or the positive film into
the required accessory.
5. Insert the accessory into the accessory slot.
6. Select the folder to save the image.
Default folder: "C:\My Documents\My Pictures".
7. In the "Photo Preview" window, set the
required image settings.
8. Take one of the following actions:
- Press the scan button to start scanning.
- Click "Capture" to start scanning.
9. Remove the accessory from the accessory slot.
10. Remove the negative film or the positive film
from the accessory.
11. Close the NimoFilm software.
12. Disconnect the USB cable from the scanner
and the PC.

Cleaning and maintenance

• Do not use cleaning solvents or abrasives.
• Do not attempt to repair the device. If the
device does not operate correctly, replace it
with a new device.
• Clean the outside of the device using a soft,
damp cloth.
• Clean the glass plate using the cleaning brush
(brush side up).
English