Storch LP Série Instructions De Montage page 10

GB
STORCH Service Department
Tel.:
Fax:
Free service hotline:
Toll-free order hotline:
Toll-free order fax:
Start by removing the intake filter from the hose on the flexible intake system and separate the bypass hose and the
hose chamber from the intake pipe.
Then route the pipe with the intake hose as shown in the photos. Make sure that you do not kink or twist the hose. (If
needed, you can turn the intake hose into the hose clamp by applying gentle force.)
Now use the tightening strap to fasten the intake pipe onto the frame pipe as shown.
Assembling on devices with a carrying frame:
Intake pipe
Tightening
strap
(turn here
if the hose flexible Intake
kinks) (do not kink!)
Wrap 3 to 4 layers of the Teflon tape provided around the thread of the upward pointing intake hose and screw the
upper container onto it.
Unscrew and remove the original bypass hose incl. adapter from the bypass valve and use the enclosed blue hose
instead. To do so, warp the threaded area of the blue hose with 2 to 3 layers of the enclosed Teflon tape and screw the
trehead into the bypass valve coupling.
Feed the end of the bypass hose from the outside through the hole in the container cover (approx. 10 cm). Secure the
hose against slipping out by attaching the enclosed cable tie, as shown in the illustration.
+49 (0)2 02 . 49 20 - 112
+49 (0)2 02 . 49 20 - 244
0800 786 72 47
+49 800 7867244
+49 800 7867243
(only available in Germany)
hose
Assembling on devices with a mobile frame:
Upper
contai-
ner
Intake
pipe
Tightening
strap
(turn here
if the hose
kinks)
10
flexible Intake hose
(do not kink!)