Installation Procedures - SVAT ClearVu 600 Manuel D'instruction

Installation Procedures (see diagram below)
Installation
1. Locate the area you would like to place your camera. Please note
that you have a maximum distance of 60ft supplied with this
unit.
2. You will have to rotate the camera bracket to uncover the
screw insertion areas. Install the camera accordingly.
Note: the camera can operate standing alone but
screws will provide more support. (Picture on right)
3. Plug the correct end of the supplied cable to the
back of the camera.
4. Locate the area where you will place your monitor
and plug it in. Make sure that the power is turned off before you
proceed. To turn off the monitor press the power button in the front
of the monitor.
5. Plug the cable into the audio/video input jacks. Make sure that the
white and yellow plugs on the cable correspond with the white and
yellow jacks on the monitor.
6. Turn the monitor on. The feed from the camera should be on the
monitor. If not, press the function switcher button to change the
channel.
7. If you would like to record on your VCR, plug RCA cables into the
audio/video output jacks on the monitor and match them into the
corresponding jacks on your VCR input jack. Switch to your VCR's
input channel and you can now record.
to power outlet
5
w w w . s v a t . c o m
Easy View
Instructions