Publicité
Les langues disponibles
Les langues disponibles
English
1.
To fix the tool holder to the machine,
introduce the shank and then tighten
the 2 screws of fixations [1] (Important,
watch that the screws have the same
strength of tightening).
1
2.
Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
BW20-GSC-105-4x
3.
4.
MARK : Never use the tool holder with
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 04.03.2019
During the mounting or the dismounting
of your tools, block the broach on flats
planned for that purpose [2], using the
supplied wrench.
The tool shank diameter should never
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
empty positions. Use the supplied
protection plug.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
BW20-GSC-105-4x
Mode d'emploi 1-
Page : 2 de 2
2
Publicité
