Askoll Energy Saving 15-60/130 Instructions D'installation Et Fonctionnement page 15

4. risk of scalding.
To avoid injury before any servicing operation wait until the water has
cooled inside the circulator.
Do not touch the fluid or the circulator when temperature is higher than 60°C.
5. operating conditions
This is a circulator to be used in heating plants and for the circulation of clean water
without abrasive particles. This is not a submersible pump.
Do not use this circulator:
• With liquids other than water (e.g. flammable liquids, etc.) (EN60335-2-51);
• For handling drinkable water or food related liquids;
• For the circulation of domestic water;
• In locations where special condition prevail, such as the presence of a corrosive or
explosive atmosphere (dust, vapor or gas) (EN60335-2-51);
• For other than intended use.
never run the circulator dry. The circulator must be always fully filled
with water when operating.
6. installation
The circulator must be mounted in a stable/fixed position in a dry, well ventilated,
frost-free, waterproof and protected place, with sufficient ventilation around it.
Make sure that the circulator is securely and correctly installed before operating it
and that there is enough room around it for maintenance operations, dismantling,
checking for free inspection.
The maximum ambient temperature at which the pump is to be used is 40°C
(EN60335-2-51) - see chart 2.2.
To avoid circulator overheating, do not place any object on the circulator itself.
7. electric connection
imPortant - A disconnection device from the supply mains having a
contact separation in all poles that provide full disconnection under
overvoltage category III conditions must be incorporated in the fixing
wiring in accordance with the wiring rules. (EN 60335-2-51)
Electrical connection must be carried out only by a qualified electrician and in
accordance with local regulations and both data on the name-plate and the
appropriate diagram inside the terminal box cover. follow all safety standards.
Do not connect to mains supply unless circulator is fully and correctly assembled.
8. Supply cord must be selected following the requirements of
EN60335-2-51 Chapter 25. Supply cord must be protected against any
kind of mechanical damage (cuts, abrasion, etc.). It must not touch the
pipe or the pump. (EN 60335-2-51)
If the insulation of the Supply cord can come in contact with parts having a
temperature exceeding 70°C the supply cord insulation must be protected,
13