Newteck Classic Flame Mode D'emploi page 13

CONFIGURACIÓN DEL TERMOSTATO:
• Adjust the desired temperature with the wheel, to lower the
temperature, turn the knob to the left (-) and to increase it, turn
it to the right
• The thermostat controls the temperature automatically, once the
marked temperature is reached in the room, the motor will stop.
SECURITY SYSTEM
• The device is equipped with an automatic turn-off system in
case of accidental fall. If the heater grill is clogged, or if the
heater gets too hot, the device will automatically turn off the
heater. To restart operation, turn off and unplug the heater, until
it cools down, at least for 10 minutes, plug it back in. Make sure
the heater is on a flat, level surface without obstructions.
Before you put the device back into its packaging, make sure it
has cooled down sufficiently.
MAINTENANCE
Disconnect the plug from the socket and let the appliance cool
down well before cleaning it.
This appliance does not require any special maintenance.
• In order to clean the appliance, use a soft or slight damp cloth.
• Never use abrasives or chemical solvents.
• Do not use very wet substances, liquids or cloths to prevent
water from entering into the appliance and irreparably damaging
it.
• Use a vacuum cleaner or a duster to keep the heat and ventilation
area clean and free of dust and dirt.
• NEVER IMMERSE THE APPLIANCE INTO THE WATER.
(+).
13