Technical Characteristics; Use And Functioning - Newteck Classic Flame Mode D'emploi

TECHNICAL CHARACTERISTICS

• Realistic flame effect
• 2 heat powers
• Ventilation heating
• AC 220-240V, 50Hz, Potencia: 750/1500W
ASSEMBLY
Using a screwdriver, pass three screws through the holes in each
leg as in Fig. 1, then press them to the right at the bottom of the
heater. Please note: additional screws are provided, some may
remain after assembly.

USE AND FUNCTIONING

Place the device on a flat surface and always in an upright position,
Before plugging or unplugging the device, make sure the operating
switch is in the OFF position, connect the plug into the socket,
connect the switch:
To activate the heat, turn on the temperature wheel and the ON/
OFF button ( ), then select the power operation (I ó II). To activate
temperature II, activate button I and II.
12
Temperature wheel: adjustable thermostat
ON/OFF: Turn on the device and the decorative
flame (no heat), you can operate the device only
with the chimney effect.
I: low power operation (750W)
I + II (combinated): high power operation (1500W)