Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Action
Switching On and Off
Setting the Impact Rate
Observing the service
indicator
Maintenance and Cleaning
For safe and proper working, always keep the
machine and ventilation slots clean.
If the replacement of the supply cord is necessary, this
has to be done by SPIT or an authorised SPIT service
agent in order to avoid a safety hazard.
Service Indicator
(see Fig. 7, page 78)
When the carbon brushes are worn out, the machine
switches itself off. This is indicated approx. 8 hours
beforehand by the lighting or blinking of the service in-
dicator . The machine must then be sent to an after-
sales service agent.
Service indicator flashes in regular intervals, the ma-
chine is defective. In this case, do not continue to use
the machine and send it immediately to an after-sales
service agent.
After-sales Service and Applica-
tion Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product
as well as spare parts. Exploded views and informa-
tion on spare parts can also be found under:
www.spit.com
The SPIT application advice team will be happy to
help you with any questions about our products and
their accessories.
In all correspondence and spare parts order, please
always include the 6-digit article number given on the
type plate of the machine.
1 609 92A 1HH • 5.8.15
Figure
Please observe
5
6
7
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According to the European Directive
2012/19/EU for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must be
collected separately and disposed of in
an environmentally correct manner.
Subject to change without notice.
Page
78
78
78
English | 12
Publicité
Table des Matières
