Charging Instructions - COOK Medical DP-M350 Mode D'emploi

ENGLISH
Charger for Blood Flow Monitor - DP-M350
Instructions for Use
Read these instructions before using the charger
This product is designed for indoor use only and should not come into contact with water or
dust. To prevent overheating the product should not be covered during use.
The mains socket should be easily accessible. In the event of operational error, the plug
should be immediately removed from the socket.
The product contains dangerous voltages and the cover should not be removed. All service
or maintenance work should be carried out by qualified personnel who can get assistance
by
The unit is double insulated (in insulation class II).
System: The Charger for Blood Flow Monitor DP-M350 (DP-M350-CHG1) is to be used with the Cook
Doppler Blood Flow Monitor (DP-M350).
Technical specification: See product labeling.

CHARGING INSTRUCTIONS

1. Do not connect the charger to the mains before it is connected to the monitor.
2. Connect the charger to the mains.
3. When charging is complete, disconnect from the mains before removing monitor connections.
CHARGE INDICATOR (LED)
RED – Indicates battery pack is being charged.
GREEN – Indicates battery pack is fully charged
USE OF ALTERNATE (SUPPLIED) PLUG ADAPTERS
1. The charger (DP-M350-CHG1) for the Doppler Flow Monitor (Model: DP-M350) is supplied with various
plug adapters that are configured to connect to regional mains input connections. The charger is designed
to operate at input voltages of 100-240VAC 50-60Hz max 0.35A without any action on the part of the user.
2. Prior to using the charger, confirm that the voltage at the mains is compatible with the unit.
3. Select the appropriate plug adapter for the local mains.
4. If the appropriate plug adapter is not connected to the primary charger unit, remove the existing plug
adapter by pressing on the grated area directly beneath its output plugs while pushing in the direction
of arrow (Figure 1a) or by placing fingers directly below the elevated plug adapter and pushing upward
and away from the cable (Figure 1b). The attached plug adapter will detach and slide upward and off the
primary charger unit.
contacting the manufacturer's agent.
3