Medisana MTR Mode D'emploi page 29

The automatic adjustment of time and date may last up to 9
minutes. If no signal is received within this time, time and date will
continue to run without changement (e.g. 0:00....0:01.....0:02 etc.).
You may now set time and date manually. If you have changed the
position of the unit, a new DCF77-signal receiving process may be
started by pressing SET button
(the symbol will flash) with the buttons "+/A"
another press on the SET button
will automatically switch to the manual time and date setting mode.
Manual adjustment:
Press the SET button
mode
the buttons "+/A"
into manual adjustment mode. At first, the year figure will flash. Adjust
the value with the buttons "+/A"
button
minute and time difference (you can adjust the time difference of the
actual time zone in regard to the middle european time zone MEZ). After
finishing all inputs, press SET button
3.5
Press the SET button
Adjusting
mode
the alarm
with the buttons "+/A"
to get into alarm adjustment mode. Select one of the following main
alarm functions: "OnA" = wake-up with alarm tone; "OnS" = wake up
with radio or "Off" = alarm deactivated. Select the desired function with
the buttons "+/A"
NOTE
If you want to leave the automatic time setting mode,
press the START button
NOTE
The device automatically receives the radio signal to
update the time setting twice a day, at 2.05 a.m. and
2.05 p.m. During this process, the Radio clock symbol
is flashing. By pressing the START button
T
regular reception of the time signal can be switched off.
to enter the setting mode. The LED for this
=
is flashing. Select the time-/date-display (display will flash) with
£
resp. "-/B"
%
. Repeat this process in the same manner for month, day, hour,
=
NOTE
If you want to leave the manual adjustment mode, press
START button . The unit automatically leaves the mode
(
after approx. 1 minute without any inputs.
to enter the setting mode. The LED for this
=
is flashing. Select the Alarm-symbol
£
resp. "-/B"
%
resp. "-/B"
%
3 Getting started
.
(
, selecting the radio clock symbol
=
resp. "-/B"
%
. If no receipt is possible, the unit
=
and press SET button
&
resp. "-/B" and confirm with SET
%
&
once again.
=
(symbol will flash)
Z
and press SET button
&
and press SET button
&
GB
and
&
the
(
again to get
=
again
=
again.
=
21