BST UHF-2400 Manuel D'utilisation page 11

UHF-2400
ACT FUNCTION
The operating ACT system is very simple, the receiver of ACT series are all has ACT button. If setting the frequency of the transmitter, press
ACT button, the LCD screen wiil displays and flash the data of ACT channel, then put the transmitler's infrared to receiver's about 30cm, the
transmitter's frequency will Auto locks on to an interference-free frequency of the receiver and the LCD screen wiII displays the RF signal.
ACT is the short of Automatic Channel Targeting . This exact and advanced operating instead of the tradition for avoid the operating error.
Press SET button, the LCD screen will displays and flash AUTO .and the receiver will locks on to in Interference-free frequency
-
automatically.
-
And then put the transmitter's infrared to receiver's, then press SET button again. The LCD screen will displays scan
symbol.
a. If this operating succeed, the transmitter's frequency will auto locks on to an interference free frequency
of the receiver.
b. If this operating fail, the LCD screen will displays and flash IR END. Press SET button two times, the
LCD screen will display normal. Repeat operating till operating succeed.
.
HANDHELD TRANSMITTER
DESCRIPTION
© Copyright LOTRONIC 2012
1) On/Off button
To turn on, press and hold the power button located on the
bottom cap of the transmitter for 2-3 seconds, until the LCD
screen's light 1s on. To turn off, press and hold the power button
until LCD screen's light 1s off
2) Built-in antenna
3) Sensitivity selector
Use to select RF power.
4) Battery cover
lnsert 2 "AA" batteries into the batlery slot, putting battery's
polarity on different ends may damage system and your warranty
may determinated if damage does occur because of it.
5) Frequency selector buttons
Adjustment buttons to adlust system statuses
6) Setup buton
Opens the different statuses your system lets you adjust, and
adjustrnent confirmation.
7) Infrared sensor
8) Grill and cartridge
9) LCD display
WWW.BSTDJ.COM
Page 11