Insertion Into The Niche - Brandt VH900WE1 Guide D'installation

2 / INSTALLING YOUR DISHWASHER
EN
•

INSERTION INTO THE NICHE

•
Glue on the anti-condensation plate
P2
(Fig. 3.1)
•
Glue on the foam sound-proofing
P3
seal (Fig. 3.1)
•
Clip the three cups
feet to make the dishwasher
easier to slide (Fig. 3.1).
If the worktop is in marble or a similar mate-
rial, you must fix your dishwasher using the
side screws; before inserting it into the
niche, you must therefore unfold a flange on
each side of the side panels (Fig. 3.2).
•
Remove the hose brackets
(Fig. 3.3)
•
Slide the appliance into the
niche,
TAKING SPECIAL CARE NOT TO
KINK THE HOSES
• LEVELLING BY ADJUSTING THE FEET
The front feet are adjustable. Use the wrench
provided to adjust them, if necessary.
The central foot can be adjusted using the red
wheel (screwdriver with No. 8 plug, No. 8 pipe
wrench or T20 Torx screwdriver).
The appliance must be correctly levelled so that
the door closes and seals perfectly (Fig. 4).
Ensure that the dishwasher's door closes cor-
rectly, without catching or rubbing against the
sides.
P1
under the
.
Fig. 3.1
Fig. 3.2
Fig. 3.3
-
Fig. 4
19
+