Troubleshooting - Geemarc CLEARSOUND LoopHEAR 101 Mode D'emploi

TROUBLESHOOTING

The RED LED is flashing
• Charge the battery
The LoopHEAR
• Make sure that the batteries are fully charged
You cannot hear clearly due to interference or you cannot
hear at all
• Make sure the LoopHEAR
• Move the LoopHEAR
BATTERY USAGE:
To ensure that your LoopHEAR
please follow the recommendations below:
• Always switch off when not in use
• Always recharge the batteries after continuous use for more
than 6 hours or when the red LED is ON
• Recharge the batteries every four months if the unit has
been switched OFF for long periods of time
As a rough guide the battery will allow the following usage
depending on the volume levels and ambient noise:
• Standby when turned Off
• Standby when turned On but not in use
• In continuous use from fully charged battery
TM
keeps on switching off
TM
TM
closer to you
14
is switched on and facing you
TM
is always ready for use
4 MONTHS
1.5 to 2 DAYS
5 to 8 HOURS