Locating The Loophear Tm - Geemarc CLEARSOUND LoopHEAR 101 Mode D'emploi

Please use the strain relief mechanism as displayed. This
provides extra protection for the cable at the connection point. It
will extend the life of the power cable and reinforce the
connection to the equipment.
The LoopHEAR
use. The power indicator will blink red while the battery is
charging. When the power indicator is blinking green, the
battery is fully charged.
Locating the LoopHEAR
In order to receive the optimal sound from the LoopHEAR
ideal location is facing the user. There are two options when
locating the LoopHEAR
Fully Portable
The LoopHEAR
without the base plate attached. It can be used in a variety of
locations with no setup required and can be used immediately.
Semi Fixed
If you want to ensure the LoopHEAR
it can be used as a semi fixed unit as follows:
1) Choose the location to fix the LoopHEAR
the range of coverage available (see below). Ensure you make full
use of it.
2) Remove the base plate – as described in Battery Charging above.
3) Screw the base plate to the table or desktop with the screws
provided.
4) Replace the base plate – as described in Battery Charging above.
INSTALLATION
TM
will need to charge for 4 hours before it's first
TM
TM
.
TM
can be used as a fully portable unit with or
LH100
120°
10
TM
stays in one place then
TM
. Please bear in mind
0.8m
TM
, the