Turn The Loophear Tm On; Using The Hand Held Hac Receiver - Geemarc CLEARSOUND LoopHEAR 101 Mode D'emploi

USING THE LoopHEAR
Turn the LoopHEAR
Turn the power switch found at the rear of the unit to the I
position. The power indicator lights up (solid green if the power
adaptor is not plugged in, blinking green if it is plugged in).
When the power is low, the indicator will light up red (solid red if
the power adaptor is not plugged in, blinking red if it is plugged
in).
Plug in the power adaptor to recharge the battery.
Turn the LoopHEAR
After use, turn off by setting the power switch at the back of the
unit to the 0 position.

Using the Hand held HAC Receiver

TM
On
TM
Off
A Hand held HAC receiver is supplied for
hearing impaired users who do not use a
hearing aid, do not have a 'T' coil hearing aid
or wish extra privacty afforded by the hand
held listener.
Simply, plug the hand held listener into the
jack (3.5mm), found at the rear of the
TM
LoopHEAR unit.
The user must press and hold the receiver
button to get the audio signal.
The volume can be adjusted by using the
volume knob also found at the rear of the unit
(turn knob clockwise to increase volume).
12
TM