Greencut GS560L Manuel D'utilisation page 62

62
HOW TO ATTACH THE CHAINSAW
Always hold the saw with your right hand on the rear handle and your left hand on the front handle. Grasp both
handles with your thumbs and fingers around the handles. Make sure your left hand is holding the front handle so
that your thumb is underneath.
START THE CHAINSAW
Before starting operation, the battery must be installed in the machine.
To start the machine:
1. Pull the front cover/chain brake lever firmly towards the front
handle until you hear a click.
2. Pull the trigger release with your thumb.
3. Pull the throttle trigger.
Once the throttle trigger is pulled, the trigger release is fixed and you can
release it.
ATTENTION: If the chain brake does not stop the chain immediately, or if the chain brake does not
remain in the activated position without assistance, take the chain saw to the Official Technical
Service for repair before use.
2
2
3