Changing The Operating Mode; Error Messages - ensto One Home EVH161-HC000 Guide D'utilisation

13.3. Application user interface
Charged energy /
Charging current
Start / Stop charging
Home screen
Note! If you have a 3-phase charger (EVH163... / EVH323...) and all phases are connected, the
application shows the highest charging current and the charged energy is calculated from that
value. The actual total charged energy may be lower than calculated.

13.4. Changing the operating mode

The default setting for the charger is "Free charging".
•
You can change the operatiing mode to "Authorized" in "Settings / Charger operating
•
mode".
• In the "Authorized" mode you start and stop charging with the application.
13.5. Changing the maximum charging current
• The nominal charging current depends on the charger type.
• If your installer has set the maximum charging current to a lower value, it is due to
restrictions on the installation site.
• You can charge your vehicle at a lower current than the set maximum value. Notice that
in that case it takes longer to charge your vehicle fully.
• You can set the charging current from home screen or "Settings / Max charging current".

13.6. Error messages

At error state, an error code appears on the screen of your mobile device. See the table below for
the cause and corrective actions.
Code
The charger has received incorrect infor-
E01
mation from the vehicle.
The fault current detection sensor is de-
E02
fective.
E03 The charger has an internal malfunction. Contact service.
6 / 52
My devices
Available devices
Cause
RAK135 / 9.9.2021
Device settings
Application settings
Corrective action
Switch off the charger from the main switch and
then switch it on again. If the error occurs again,
contact service.
Contact service.
Connected charger
Set max. charging
current
Charger's max. charging
current
Available updates
Error log
Device manuals
Demo mode
Application version